Table of Contents
Advertisement
5. Intermittent images for short
periods
6. The equipment does not find
the satellite (the led on the
control unit is red)
7. The equipment does not find
the satellite (the led on the
control
unit
flashes
nately red and orange)
8. Disturbed images
9. Confused,
incomplete
obstructed images
www.glomex.it
- the
satellite
obstructed by masts of other
boats,
bridges,
equipment, etc.
- the boat is at the boundary of
the coverage area
- bad weather conditions
- wrong SKEW adjustment
- the
satellite
obstructed by masts of other
boats,
bridges,
equipment, etc.
- the boat is outside the signal
coverage area
- the boat is heaving within the
first 60 seconds after turning
on the equipment
- bad weather conditions
- inner failure
- wrong SKEW adjustment
- the
satellite
obstructed by masts of other
alter-
boats,
bridges,
equipment, etc.
- the equipment software is not
up to date
- wrong SKEW adjustment
- failure of the receiver
and
- condensate or rain on the
radome, which can disturb the
signal
- bad weather conditions
- wrong SKEW adjustment
signals
are
- move the boat to allow an
unobstructed
on-board
antenna
- go back within the coverage
area; refer to the footprints of
the coverage areas on page
58 in this manual
- adjust the SKEW by following
the instructions on page 52
signals
are
- move the boat to allow an
unobstructed
on-board
antenna or correctly position
the antenna on the boat
- go back within the coverage
area; refer to the footprints of
the coverage areas on page
58 in this manual
- turn off the equipment for 10
seconds, turn it on again and
make sure that the boat is still
or moves in a straight line dur-
ing the first 60 seconds after
being turned on
- contact the Service Centre
- adjust the SKEW by following
the instructions on page 52
signals
are
- move the boat to allow an
unobstructed
on-board
antenna
- please contact the Service
Centre to ask for the software
update by SD card
- adjust the SKEW by following
the instructions on page 52
- refer to the user manual of the
receiver for support, spare
parts and warranty conditions.
- remove the condensate depos-
its from the radome with a fresh
water jet (not under pressure)
- periodically
detergent suitable for dishes
(no alcohol-based detergent)
to the radome surface and let
dry up
- adjust the SKEW by following
the instructions on page 52
65
RHEA V8100S2
view
for
the
view
for
the
view
for
the
apply
a
liquid
Advertisement
Table of Contents
