Table of Contents
Advertisement
WARNING: Switch off the running
boards before jacking or placing any
object under your vehicle. Never place
your hand between the extended running
board and your vehicle. A moving running
board may cause injury.
WARNING: Only use the spare
wheel carrier to stow wheels provided
with your vehicle.
WARNING: Ensure screwthread is
adequately lubricated before use.
WARNING: Switch the ignition off
and apply the park brake fully before
lifting vehicle.
WARNING: Use only the specified
jacking points. If you use other locations,
you could damage the body, steering,
suspension, engine, braking system or
the fuel lines.
WARNING: Park your vehicle so
that you do not obstruct the flow of
traffic or place yourself in any danger and
set up a warning triangle.
1.
Park the vehicle on firm, level ground
and activate the hazard flashers.
2. Apply the parking brake, place the
transmission in park (P) and switch the
ignition off.
3. Block the wheels diagonally opposite
the flat tire, for example, if the left front
tire is flat, block the right rear wheel.
2022 Expedition (TB8) Canada/United States of America, enUSA, Edition date: 202109, First-Printing
Changing a Road Wheel
91
E175447
Removing the Jack and Tools
Note: Pay close attention to the orientation
of the jack and tool kit bag, because it needs
to be reinstalled after changing the tire.
1.
Open the liftgate and lift the load floor
behind the third row seat. If your
vehicle has an access panel, you need
to then unlatch and remove this panel.
2. Remove the wing nut by turning it
counterclockwise.
3. Remove the jack and tool kit bag from
the bracket, loosen the straps and
remove the tool bag from the jack.
E252435
Advertisement
Table of Contents
Troubleshooting
