Page 4
Step 1 Assemble S1C and S3C frames to make up the main structure using CB1 brackets in the corners and JF1 brackets on the straight joints. MEASUREMENTS IN BLUE - MM MEASUREMENTS IN GREEN - INCHES USE DIMENSIONS TO CHECK ALIGNMENT OF THE SHELTER Ensure correct alignment on corners...
Page 5
Step 2 Attach R3 rafters using RB1 brackets on the back of the shelter and L3 brackets in the middle.
Page 6
Step 3 Assemble the B3's and P4 using the JF1 and RB1 brackets as Attach front beams (B3) and centre post (P4) to the shown below. rafters using the L1 brackets. DETAIL A SCALE 1 : 5 DETAIL B SCALE 1 : 4...
Page 7
Step 4 Attach the FT1 and FT3 foot brackets, Move the Shelter into its final position and make sure its square. Then use concrete anchor bolts to secure it to the the ground.
Page 8
Step 5 Apply the sealing strips (SS) to the top of the R3 rafters as shown. Place ACE3 and the ACC3 roof panels with a small gap on sealing strips use RC3 strips and screws supplied to secure panels in place. Finally screw A2 angles to the rear of the shelter.
Page 9
PLAN VIEW OVERALL DIMENSIONS AND GROUND FIXING POSITIONS Suggested size for concrete base: 200mm or 7.87in oversized on all 18.78 four sides. 20.73 526.50...
Touch up any exposed metal should it get scratched CONTACT DETAILS: Email : Sales@nobutts.com Web : www.nobutts.com Tel : 1-888-662-8887 No Butts Bin Company, Inc. 16 Birch Lane, Madison, CT 06443 All Parts and Fixing checked by: Print Name: Signature:...