PARTS LIST PART ITEM DESCRIPTION DIMENSION IMAGE QTY. Frame 4 x 40 Post Roof Tie Bracket 8 x 4 Bracket 8 x 1 Bracket 8 x1 Rafter Sealing Strip PCE2 Roof Panel 8 x 41 Roof Strip Roof Edge trim Bracket 8 x 3 Plastic End...
Page 4
Step 1 Assemble S1 frames to make up the main structure using CB1 brackets in the corners and JF1 brackets on straight joints. Then attach P1 Post using one JF1 bracket. Then attach ST1 Tie bar using a JF1 bracket and one CB1 bracket. GENERAL NOTE: THE 2"...
Page 5
Step 2 Move shelter in to its final position, make sure everything is square and secure to the floor using FT1 foot brackets. Attach R2 roof rafters using RB2 brackets. 2 " 2 "...
Page 6
Step 3 Apply SS sealing strips to the rafters (two per rafter) and line up the PCE2 roof panels to the outside of the shelter, leaving a gap between them. PCE2 PCE2 SS SS SS SS SS SS...
Page 7
Step 4 Apply RC2 strips on top of the panels and use screws to secure them in place. Then clip on the 2MD edge trim to the bottom of the roof panels. Then fit the Black plastic caps on exposed nuts and bolts. Fit the square plastic end caps to any open ends of box sections.
Ensure all fitting are tight (for example after a big storm) • Touch up any exposed metal should it get scratched CONTACT DETAILS: Email : Sales@nobutts.com Web : www.nobutts.com Tel : 1-888-662-8887 No Butts Bin Company, Inc. 16 Birch Lane, Madison, CT 06443...