Table of Contents
Advertisement
Quick Links
Clothes Dryer
Electric and Gas Models
Original Instructions
Keep These Instructions for Future Reference.
CAUTION: Read the instructions before using the machine.
(If this machine changes ownership, this manual must accompany machine.)
DRY722C_SVG
Part No. D514761ENR6
www.alliancelaundry.com
July 2019
Advertisement
Table of Contents
Related Manuals for Alliance Laundry Systems DRY722C-SVG
Summary of Contents for Alliance Laundry Systems DRY722C-SVG
- Page 1 Clothes Dryer Electric and Gas Models Original Instructions Keep These Instructions for Future Reference. CAUTION: Read the instructions before using the machine. (If this machine changes ownership, this manual must accompany machine.) DRY722C_SVG Part No. D514761ENR6 www.alliancelaundry.com July 2019...
- Page 3 Installation and service must be performed by a appliance. qualified installer, service agency or the gas sup- plier. W053 W052 This product uses FreeRTOS V7.2.0 (www.freertos.org). © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
- Page 4 A “T-Handle” type gas shut-off valve must be installed in the gas supply line to this appliance. • This appliance must not be installed in a bedroom or bath- room. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
-
Page 5: Table Of Contents
To Insert Card................... 33 © Copyright 2018, Alliance Laundry Systems LLC All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. - Page 6 Dryer Interior....................35 Cabinet.....................35 Control Panel.................... 35 Exhaust System..................35 Lint Filter.....................35 Motor Overload Protector................36 For Energy Conservation................36 Troubleshooting..................37 Contact Information................39 Installer Checklist.................40 © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
-
Page 7: Safety Information
Read all instructions before using the dryer. • Use the dryer only for its intended purpose, drying clothes. ALWAYS follow the fabric care instructions supplied by the © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... - Page 8 Failure to install, maintain, and/or operate this machine ac- cording to the manufacturer’s instructions may result in con- ditions which can produce bodily injury and/or property dam- age. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
-
Page 9: Dimensions
*392 mm [15.44 in.] *994 mm [39.13 in.] NOTE: Exhaust openings are 102 mm [4 inch] metal * With leveling legs turned into base. ducting. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... - Page 10 NOTE: Exhaust openings are 102 mm [4 inch] metal * With leveling legs turned into base. ducting. NOTE: Gas models cannot be vented out left side of cabinet because of burner housing. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
- Page 11 For maximum drying per- formance, we recommend that more clearance be al- lowed around the dryer than the clearances that are lis- ted throughout this manual. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
-
Page 12: Installation
Additional Security Torx security screws are available (as optional equipment at extra cost) for securing lower access panel to each dryer base. Order part number 62853. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... - Page 13 Area Description Free Standing/Alcove Installation Dryer sides 0 mm [0 in.] Dryer top (rear 610 mm [24 in.]) 305 mm [12 in.] Table 1 continues... © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
-
Page 14: Connect Dryer Exhaust System
If secon- building. dary systems are mandated, frequently clean the system to assure safe operation. W045 W749 © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... -
Page 15: Exhaust Direction
• Static pressure in exhaust duct should not be greater than 1.5 cm water column [0.6 inches water column], measured with © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... -
Page 16: Multi-Dryer Installation Exhaust Requirements
2.4 m [7.87 ft.], Note how each dryer has its own exhaust system vented to the as required to meet UL2158, clause 7.3.2.A. central exhaust duct. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... - Page 17 2. Clean Out Cover (Must be provided). Inspect monthly. 3. Weather Hood or Sweep Elbow (No cap or screen) 4. 610 mm [24 in.] Minimum Clearance to Roof/Ground Figure 5 © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
- Page 18 305 mm [12 inches] 326 mm [13 inches] 356 mm [14 inches] 381 mm [15 inches] 381 mm [15 inches] 406 mm [16 inches] Table 3 © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
-
Page 19: Gas Dryers - Connect Gas Supply Pipe
Altitude Orifice Size Gas Dryers - Connect Gas Supply Pipe mm [in- Part m [feet] ches] Number 610 [2,000] 2.44 D503776 [0.0960] Table 4 continues... © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... - Page 20 Refer to Table 5 . Union at gas supply connection (listed to ANSI Z21.24 and CSA 6.10). © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
-
Page 21: Electric Dryer Only - Connect Electrical Plug
© Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... - Page 22 6. Strain Relief (Not supplied with dryer) 2. Power Cord 7. Ground Screw 3. Stain Relief Nut 8. “L1” Terminal 4. Strain Relief Figure 10 Figure 9 © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
-
Page 23: Connecting Power Cord With Three-Wire Plug
4. Neutral Terminal 5. “L2” Terminal 6. Black Wire 7. White Wire (Neutral) 8. Strain Relief (Not supplied with dryer) 9. Red Wire Figure 11 © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... - Page 24 15. Direct Connection 16. Power Cord Connection Figure 12 1. Disconnect power to dryer. 2. Remove access cover from rear of dryer. D695I_SVG Figure 13 © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
-
Page 25: Connecting Power Cord With Four-Wire Plug
Connecting Power Cord with Four-Wire Plug NOTE: Four-wire cord is required for new branch-cir- cuit installations, mobile homes or where codes do not permit grounding through neutral. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... -
Page 26: Reverse Door, If Desired
10. Reinstall access cover and screw. Reverse Door, if Desired NOTE: Doors with windows cannot be reversed. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... - Page 27 DRY1918N_SVG Figure 26 7. Reinstall nine screws removed in Step 2. DRY1916N_SVG Figure 23 4. Rotate door panel 180 degrees as shown. DRY1919N_SVG Figure 27 © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
-
Page 28: Wipe Out Inside Of Dryer
Connect the dryer to an electrical power source. Refer to Connect Electrical Plug section for information on connecting power cord. Connect to 30 Amp Circuit D275I_SVG2 Figure 31 © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... -
Page 29: Gas Dryer
110/120 Volts AC (alternating current) 15 Amps. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... -
Page 30: Recheck Steps
Electric Dryers 1. Close the loading door and start the dryer in a heat setting (re- fer to the operation instructions). © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... - Page 31 3. 3.1 mm [1/8 in.] Pipe Plug (For checking manifold pressure) 4. Shut-off Valve Open Position 5. Shut-off Valve Closed Position 6. Shut-off Valve Handle Figure 33 © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
-
Page 32: Operation
2. Add fabric softener sheet if desired. IMPORTANT: To avoid damage to dryer, do not use more than one fabric softener sheet per load. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... -
Page 33: Insert Coins Or Card
(cool down cycle) to ensure that items in dryer are left at a temperature that ensures that the items will not be damaged. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... -
Page 34: Indicator Lights
COOL DOWN is lit whenever the COOL DOWN portion of a heated cycle is active. It is also lit when the NO HEAT cycle is in operation. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... -
Page 35: Maintenance
Exhaust System WARNING D608I_SVG1 1. Lint Filter To reduce the risk of electric shock, disconnect the electrical service to the dryer before cleaning. Figure 42 W043 © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... -
Page 36: Motor Overload Protector
Should you plan to dry several loads, do them one after anoth- er, then you do not have to reheat the dryer unit’s interior parts each time. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... -
Page 37: Troubleshooting
Normal operating sounds include the heat source going on and off and the humming of air moving through the dryer and exhaust system. Table continues... © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... - Page 38 • Ventilate room before drying clothes. © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
-
Page 39: Contact Information
+1 (920) 748-3950 for the name Table continues... and address of the nearest authorized parts distributor. DRY2527N_SVG 1. Serial Plate Figure 43 © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT... -
Page 40: Installer Checklist
Start and Run Dryer in Heat Setting to Verify Dryer is Heating. • Connect Electrical Cord. CHECK CHECK D699I_SVG1 Reverse Door, if De- sired. CHECK D675I_SVG1 Refer to the manual for more detailed information © Copyright, Alliance Laundry Systems LLC - Part No. D514761ENR6 DO NOT COPY or TRANSMIT...
Need help?
Do you have a question about the DRY722C-SVG and is the answer not in the manual?
Questions and answers