Power-On Utilities - Gainscha GI-6404T Series User Manual

5.2 Power-on Utilities

This printer has six power-on functions for setting or testing the printer's hardware. Press these
buttons at the same time when the power is turned on, and release the buttons with the light signal to
activate these functions.
Follow these steps to enable the boot function:
Event
Self-test
A. Power off the printer
B. Make sure the printer is loaded with paper and close the printer cover
C. Press and hold the FEED button and turn on the printer. When you
hear a beep, release the FEED button. At this time, the printer will print a
self-test page.
Enter USB
A. Power off the printer
storage
B. Make sure the printer is loaded with paper and close the printer cover
device
C. Press and hold the PAUSE button and turn on the printer. When you
function
hear a beep, release the PAUSE button, and the printer's storage device
will appear on the computer.
Enter dump A. Power off the printer
mode B. Make sure the printer is loaded with paper and close the printer cover
C. Press and hold the PAUSE and FEED buttons at the same time for
two seconds, then turn on the printer's power. When the online Blue and
the error Red are on at the same time, release PAUSE and FEED
buttons, when you hear a beep, the printer enters the dump mode and
will print out "NOW IN DUMP MODE"
Skip
A. Power off the printer
AUTO.BAS
B. Press and hold PAUSE and FEED buttons for four seconds at the
same time, and turn on the printer power until the power Blue is off, and
the error Red is on, release PAUSE and FEED buttons, two beeps are
heard. At this time, the printer will skip the AUTO.BAS program, and then
the power light is on
Printer A. Power off the printer
initialization B. Press and hold PAUSE and FEED buttons at the same time for six
seconds, and turn on the printer power until the printer online Blue is on
and error Red is off, release PAUSE and FEED buttons, five beeps are
heard. At this time the printer will restore the printer parameters to the
factory default settings
Ribbon The machine will automatically detect the status of the ribbon after
inspection turning on and in each thermal transfer printing mode.
Description
37
Status lights Beep