Loading The Media - Gainscha GI-6404T Series User Manual

3.4 Loading the Media

3.4.1 Loading the Media
1.
Move the label roll guard horizontally to the end
of label spindle, then flip down the label roll guard.
3.
Pull the Print head release lever to open print head
mechanism.
5.
Move the media sensor by adjusting the media
sensor position adjustment knob, make sure the gap or
black mark sensor is at the location where media
gap/black mark will pass through for sensing. Adjust the
label guide to fix the media position.
2.
Place the media roll on the label supply spindle and
use label roll guard to fix it.
4.
Install the label through the media guide bar,
damper, media sensor, and label guide to install the media.
(See the "Media Loading Path" illustration below).
6.
Close the print head mechanism on both sides and
make sure the latches are engaged securely. Set media
sensor type and calibrate the selected sensor.
25