Using Fan Mode; Using The Timer Function - Silvercrest PD-8871 Operation And Safety Notes

tank" or "Using continuous water
drainage".
Press the POWER button
to switch on the product.
Press the MODE button
repeatedly until the mode indi-
cator shows DEHUM. The
20
product is now in dehumidifica-
tion mode.
Note: The temperature is auto-
matically set to approx. 2 °C
below the currently measured
room temperature and shown
on the display
The temperature cannot be set
manually in this mode.
The fan speed is automatically set
to LOW and indicated by the
fan speed indicator
speed cannot be set manually
in this mode.
To turn off the product, press the
POWER button

Using fan mode

Note: You can remove the hot air
outlet hose from the product when
13
operating in fan mode.
Press the POWER button
to switch on the product.
Press the MODE button
repeatedly until the mode indica-
tor shows FAN. The product
20
27
23
.
19
. The fan
17
.
27
27
23
is now in fan mode. The temper-
ature is automatically set to 25 °C
and shown on the display
temperature cannot be set manu-
ally in this mode.
Push the SPEED button
to adjust the fan speed. The fan
speed indicator
selected speed (HIGH or LOW).

Using the timer function

Automatic switch-on
Push the TIMER button
when the product is off. The dis-
play flashes and the timer
19
indicator
18
Use the TEMP– button
TEMP+ button
timer (1–24 hours). The set time
flashes on the display
Push the TIMER button
again to confirm the set time.
If the time is not confirmed and no
further entry is made, the timer
will be cancelled after about
10 seconds.
If necessary, select an operating
mode using the MODE button
. This is indicated by the
23
mode indicator
DEHUM or FAN). The timer will
start counting down the remain-
ing time and the product will turn
. The
19
22
shows the
17
12
lights up.
25
to set the
26
.
19
21
(COOL,
20
GB/IE
/
41