Honeywell Midas S2 Quick Reference Manual page 18

Fixed single-point extractive gas transmitter

Hide thumbs Also See for Midas S2:

Table of Contents

Install and leak check

1. Mount the Midas S2 using the integral mounting bracket.

2. Connect the actual inlet & outlet tubes to Midas S2 and turn on

the system.

Verify the Check-Valve is attached to the Sampled Point.

After the Power ON, wait approximately 10 minutes for pump

stabilization and corrective measures.

3. Perform a Block test to ensure internal connections are secure.

Refer to Block test in the Midas S2 User Manual for further

information.

Operation

Select MENU > TEST MODE > LIT and follow the instructions for LIT

enable, Setting, Calibration, and Manual test.

Please secure the calibration procedure for the accurate operation of LIT.

Table of Contents