Silver 1-1/8" Flat Head Screw - Sauder worksense PALO ALTO 427795 Manual

Step 6
å
Fasten the TOP BRACES (H) to the TOP (F). Use four
SILVER 1-1/8" FLAT HEAD SCREWS (10S).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
å
NOTE: The angled edge of the BRACE should face down
and toward the back edge of the TOP.

SILVER 1-1/8" FLAT HEAD SCREW

(4 used in this step)
Page 12
10S
H
F
unit number
Just think. The sooner
you do this, the sooner
you do something else.
Angled edge
Back edge
www.sauder.com/commercial-office/service
H