Rear-Panel; Hardware Installation Procedures - TP-Link TD-8610B User Manual

2.3 Rear-panel

ON/OFF: Turn on/off the ADSL modem's power.
Power (9VAC/0.8A input): please do not use any unknown power adaptor, otherwise that
may cause damage to your ADSL MODEM.
RESET (reset default): When the device is working, please press the reset button of the
Modem, keep the reset button pressed down for more than five seconds and then wait for the
router to reboot.
LAN: Connect with your computer's NIC.
LINE (WAN): Connect to the MODEM of Splitter or connect to the telephone line.

2.4 Hardware installation procedures

First Step: Connect the MODEM of Splitter with the LINE port of the TD-8610/TD-8610B ADSL2+
MODEM by telephone line. While you need to use a telephone, please attach telephone line into
the phone of Splitter.
Second Step: Connect category 5 cable with RJ45 jacks to ADSL MODEM's LAN port and your
computer's NIC.
Third Step: Link power adapter into the power jack of ADSL MODEM. Please note the range of
voltage of power adapter should be within AC 220～230V, 50Hz, which will make the MODEM
under normal operation.
Last Step: Check the line connection to see if everything is ready. Then power up.
TD-8610/8610B
4
External ADSL MODEM