The Back Panel - TP-Link TD-W8920G User Manual

WLAN Slow flash
Quick flash Sending or receiving data over wireless network
(1-4) LAN

2.3 The Back Panel

The Router's ports, where the cables are connected, and RESET button are located on the back
panel.
Line: Connect to the Modem Port of Splitter or to the telephone line.
Reset Button: There are two ways to reset the Router's factory defaults.
1) Use the Restore Default function on Management -> settings page in the router's
Web-based Utility.
2) Use the Factory Default Reset button: Press the Reset button for more than five seconds
and then wait for the router to reboot.
1, 2, 3, 4 (LAN): Through these ports, you can connect the Router to your PCs and the other
Ethernet network devices.
Power: The Power plug is where you will connect the power adapter.
Antenna: Used for wireless operation and data transmit.
TD-W8920G
Off The Wireless function is disabled
The Wireless function is enabled
Off There is no device linked to the corresponding port
On Connected to a device through the corresponding port
Flashing Sending or receiving data over corresponding port
Figure 2-2
108M Wireless ADSL2+ Router User Guide
5