Gravely Pro-Walk Hydro 36HR PS Owner's/Operator's Manual page 31

SERVICE LUBRICATION
Grease
Use a general all-purpose grease with an
NLGI grade No.2 rating.
Lubrication Points
• Apply grease to caster wheel bearings
(A) on both sides.
• Apply grease to front caster wheel
pivot bushings (B) on both sides.
• Apply grease to spindle bearings (C),
until grease is expelled from vent on
spindle housings.
Figure 24
• Apply grease to drive belt idler arm
pivot joint (D).
B
A
Figure 23
C
D
988154, 155, 157, 158
D
Spray Lubricant
See Figure 26.
Use a general-purpose petroleum-based
spray lubricant. Lubricate the following
control items:
• Apply spray lubricant to steering
control levers pivot shaft (E) (988156,
157, 158).
• Apply spray lubricant to throttle control
cable (F).
• Apply spray lubricant to choke control
cable (G)
• Apply spray lubricant to upper and
lower parking brake linkages (H).
• Apply spray lubricant to hydro pump
upper (J) and lower (K) control
linkages on both sides.
EN - 31
988153, 156
Figure 25