Promis COLpro222DX-OZview User Manual page 3

Symbols and Terminology:
Attention: Consult user's manual for additional information
Caution: This statements identifies a condition or practice, which if not corrected or discontinued
immediately, could lead to equipment failure or damage
Warning: This identifies a condition or symbols practice, which if not corrected or discontinued
immediately, could lead to patient injury / illness
WARNINGS
The Colposcope must be connected to a properly installed power outlet with protective earth contacts only. Operation
room should be ventilated and free of shock, noise, other strong interference source and direct sunlight.
•
Users of this equipment should be thoroughly trained in the appropriate medical procedures. They should take
time to read and understand these instructions before performing any procedure. They can also read and follow
instructions for any other equipment used in conjuction with the Colposcope.
•
The Colposcope should not be operated in the presence of flammable or explosive gases or chemicals, or
installed in areas where these materials are commonly used.
•
Keep all liquids away from electrical equipment to avoid the possibility of shock and instrument damage.
•
Colposcope user should adhere to the operating conditions found in this manual. Otherwise, instrument damage
may occur and patient safety may be compromised.
•
All signal input and output are intended for connection to only peripheral devices that are compliant to
IEC 60601 - 1 or other IEC standards as appropriate to the nature of the peripheral device. Connecting additional
peripheral to the video colposcope may increase the risk associated with chassis or patient leakage currents. To
maintain operator & patient safety, the user should consider the system leakage current requirements of IEC
60601-1.
•
Never stare at the illuminator because it is extremely bright and may cause injury to the eye.
CAUTIONS
•
Occasionally inspect the power cord for signs of cuts, abrasions or dents.
•
The colposcope should never be stored or operated in areas where it could get wet or could be exposed to any
environmental conditions like extreme temperature or humidity, direct sunlight, dust etc.
•
There are no user serviceable parts in this unit or in its accessories. Any attempt to disassemble and repair this
unit will result in voiding of the warranty.
•
Do not clean illuminator or lens with alcohol. Do not touch optical parts or lenses.
•
Do not sterilize
•
Do not immerse any part of the unit in cleaning solutions.
PRECAUTIONS
•
Colposcope Safety: The safety requirement mentioned in this section is for Colposcope as a whole and applies
to the instrument. The importance is not related to the sequence. NOTE: This is not a treatment device.
•
Please confirm the colposcope is in normal working condition before operation.
•
Without losing knob, the excessive force may damage twin axis adapter of colposcope head.
•
This is non-contact type examination device, avoid contacting patient during use.
•
Before turning off power supply of the whole system, never plug or unplug the video cable.
•
Without written approval of the manufacturer, user shall not remove, modify or use accessories, which do not
comply with the manufacturer's requirements.
•
When connecting the signal cables, handle them carefully. Align the connectors, do not plug or unplug with strong
force, otherwise, the cable and connectors may be damaged, which will impact the image quality or camera
power supply or even the equipment.
Operator's Manual Ver: PMA-VYR-0218NA-GIMA
- 3 - COLpro222DX-OZview