Table of Contents
Advertisement
Installation
INSTALLATION
Location
When selecting a position for your unit you should make sure the floor is flat and firm, and
the room is well ventilated with an average room temperature of between 16°C and 32°C.
Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct
sunlight as it may increase the electrical consumption. Extreme cold ambient temperatures
may also cause the unit not to perform properly. This unit is not designed for use in a garage
or outdoor installation. Do not drape the unit with any covering.
Levelling the Unit
To do this adjust the two levelling feet at the front of the unit.
If the unit is not level, the doors and magnetic seal alignments
will not be covered properly.
Installing the Spacers
Screw the spacers to the left and right side
of the unit's rear part.
screw
Free Space Requirements
When installing the unit, ensure that 25 mm
of free space is left at both sides, 50 mm
at the rear of the unit and 25 mm at the
top of the unit. The door can be opened to
the right or the left, depending on which
Max. 160°
best suits the location. Please ensure there
Y mm
is more than twice the width and depth
distance space of the unit to fully open the
door to a maximum angle of 160°.
X mm
7
Advertisement
Table of Contents
