Table of Contents
Advertisement
Installation
INSTALLATION
Location
When selecting a position for your unit you should make sure the floor is flat and firm
and the room is well ventilated. This unit can be used in a garage or outbuilding. For
optimum energy efficiency the unit should be located within an average room temperature
of between 16°C and 38°C. If the room temperature drops below or rises above these
temperatures the energy consumption and performance may be affected. Avoid locating
your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it
may increase the electrical consumption. Do not drape the unit with any covering.
Free Space Requirements
When installing the unit, ensure that 100 mm of free space is left at both sides and 100 mm
at the rear of the unit. Please ensure there is adequate space for the door to fully open at the
top.
Cleaning Before Use
Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm
water using a sponge or cloth. Wipe completely dry before replacing the shelves, drawers
and salad bin. Clean the exterior of the unit with a damp cloth.
If you require more information refer to the Cleaning section.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant fluid needs time to settle.
Before Using Your Unit
Before placing any food in your unit, turn it on and wait for 24 hours, to make sure it is
working properly and to allow it time to fall to the correct temperature. Your unit should not
be overfilled.
7
Advertisement
Table of Contents
Need help?
Do you have a question about the C99CF13 and is the answer not in the manual?