Advertisement
IMPORTANT
Safety instructions
CAUTION
Follow these instructions before
installing your flow meter to avoid
failure.
LOCATION
Meters are suitable for indoor and
outdoor use.
PRE-INSTALLATION
Before you begin
In the Box
Flow meter
Rubber gasket
Clamp x2
Quick start guide
Tools Needed
Drill
Drill bit 5/8" (1"–4" flow meter)
Drill bit 3/4" (6"–8" flow meter)
Drill bit 1/4" (Optional pilot hole)
Fine sandpaper (Optional)
Felt pen
Tape measure
Flathead screwdriver
CAUTION
Always wear eye protection when
installing or removing flow meters.
PRESSURE
Do not exceed 50 PSI (5.17 bar).
High pressure and temperature will
damage the meter.
Compatibility
Ensure the piping is either straight horizontal
or vertical SCH 40 or SCH 80.
Planning
Mounts and supports must be sturdy enough
to support the plumbing and prevent vibration.
Vibration and heavy loads will damage the meter.
Suitability
It is the responsibility of the user to determine
the suitability of the flow meter in their
application. Flow meters are tested and
calibrated for water only.
Advertisement
