Table of Contents
Advertisement
Strap Installation
8
Detailed Ratchet Strap Instructions
1
2
Open ratchet handle
Pull Strap through
flat and insert end of
strap through opening.
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
Customer Service Department 1-866-972-6168
After the ladder stand has been secured to the
tree with the installation straps, and the
8
stabilizer bar has been securely attached to
the tree, continue to have two people hold the
ladder and climb cautiously up to the platform.
Once you reach the top, IMMEDIATELY
ATTACH YOUR SAFETY HARNESS TO THE
TREE. Keep the tether strap above your head.
DO NOT sit on seat platform until
the Ratchet and Installation Straps
have been secured.
3
Insert end of strap
opening.
through slot in ratchet
wheel.
Stabilizer Bar and Installation Straps
MUST be secured prior to climbing
the Ladderstand. Failure to comply
may result in serious injury or death.
W A R N I N G
Cautiously climb to the top of the treestand. Wrap
9
the strap of the ratchet around the back of the
tree once and thread through the ratchet.
(See Detailed Ratchet Instructions Below)
4
Ratchet handle back
and forth to tighten
strap. Ensure that the
ratchet wheel makes
at least one and a
half revolutions once
installed. DO NOT
allow the ratchet
wheel to over-fill and
contact the ratchet
mechanism of the
ratchet strap.
DO NOT climb ladder without Stabilizer
Bar installed. Serious injury or death
may occur if Stabilizer Bar and
Installation Straps are not installed.
Model: HEH00774
Outpost Xl 17' Ladder Treestand
9
5
6
To release tension, push
After strap is tight,
spring loaded retaining lock
close handle to
and simultaneously pull
the locked position.
primalvantage.com/field-stream
X
on strap.
©2019 (rev. 1/19)
Advertisement
Table of Contents
