Table of Contents
Advertisement
After polling, the handheld programmer will
briefly display the total number of controllers that
were found.
When the "PRESS YOUR DESIRED FUNCTION
KEY" screen appears, you are now ready to
select the feature you want to program.
HOW TO PROGRAM CONTROLLERS
The following will provide step-by-step instructions on how to program each feature of the
Master-Trol Controller. Each set of instructions will begin from the "PRESS YOUR
DESIRED FUNCTION KEY" screen. Please see the "Keypad Definitions" section for
descriptions of each feature and mode.
NOTE: If the Handheld Programmer is connected to multiple controllers, then you will
be required to enter the controller address and station number when specifying the valve
you want to program. If you are connected to one controller, then the Handheld Programmer
will only ask for the station number. Controller address numbers should be written on the front
of the controller.
How to change the ON-TIME:
1. From the "PRESS YOUR DESIRED
FUNCTION KEY" screen, press the "ON-
TIME" button.
2. If you are connected to multiple controllers,
enter the controller address with the valve
you want to program and press "ENTER".
If not, proceed to step #3.
3. Enter the station number of the valve you
want to program and press "ENTER".
www.acorneng.com
7
Technical Support: (800) 743-8259
ON
TIME
Advertisement
Table of Contents
