Handheld Programmer Setup - Acorn MASTER-TROL User Manual

The "RESET" button will restart the Handheld Programmer without shutting off the
RESET
power. You will be required to enter the password again.
The "ESCAPE" button will remove you from your current function and return you to
ESCAPE
the "PRESS YOUR DESIRED FUNCTION KEY" screen. You can then select a new
function without restarting the Handheld Programmer.
The "CLEAR ENTRY" button allows you to clear information if you make a mistake
CLEAR
while entering data.
ENTRY
The "ENTER" button confirms the data you have entered and applies the changes.
ENTER
The "ON/OFF" button is used to power the Handheld Programmer on and off.
ON
OFF

HANDHELD PROGRAMMER SETUP

1. Install the 9V battery or connect the plug-in transformer to the Handheld Programmer.
2. Plug the interface cable into the link port on the Handheld Programmer.
CPT
Handheld
Programmer
www.acorneng.com
Link Port
(Top)
LINK
MASTER-TROL PROGRAMMER - CPT
ON LOCKOUT
TIME TIME
GLOBAL GLOBAL
ENABLE DISABLE
STATION STATION
ENABLE DISABLE
ACTUATOR VALVE
MODE MODE
STATUS
Manufacturers of Stainless Steel Plumbing Fixtures
CITY OF INDUSTRY, CALIFORNIA
Battery
Compartment
(Bottom Rear)
Plug-in Transformer
Connection (Top)
9VDC
ON
ESCAPE RESET
OFF
1 2 3
4 5 6
7 8 9
CLEAR
0
ENTER
ENTRY
R
4
Versa-Link
Interface
Cable
Technical Support: (800) 743-8259