Power Supply - Mpfb Connection - Motorola M68MPB16Y1 User Manual

MEVB QUICK START GUIDE
3.3.1 Power Supply – MPFB Connection
Use MPFB connector J5 to connect a user-supplied power supply to the MEVB.
Contact 1 is ground; black lever. Contact 2 is VDD (+5 volts); red lever. Use 20
or 22 AWG wire for power connections. For each wire, trim back the insulation
1/4 in. (.635 cm), lift the appropriate lever of J5 to release tension on the contacts,
then insert the bare wire into J5 and close the lever. The MEVB requires a +5Vdc
@ 1.0 amp power supply for operation. A 1.5 amp fuse is installed on the MPFB
+5Vdc power supply input line.
3-4
GND
Do not use wire larger than 20 AWG in connector J5. Such wire
could damage the connector.
Turn off MEVB power when installing or removing the MPB from
the MPFB. Sudden power surges could damage MEVB integrated
circuits.
BLK
+5V
CAUTIONS
RED
J5
M68MPB16Y1UM/D