Fcc Information - ICON NordicTrack NTL14815.4 User Manual

HOW TO ADJUST THE HEIGHT OF THE DESK
A
Grip each side of the desk assembly (A) in the loca-
tions shown by the arrows. Next, reach with your
fi ngertips and lift the adjustment handles (B). Then,
lift or push on the desk assembly to adjust it to the
desired height. Make sure that the desk is level.
B
B
IMPORTANT: The desk assembly (A) cannot be
raised or lowered quickly. Do not try to force the
desk to raise it or lower it quickly.

FCC INFORMATION

This console has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to
computer or peripheral devices. Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user's authority to operate this equipment.
IMPORTANT: To satisfy exposure compliance requirements, the antenna and transmitter in the console
must be at least 8 in. (20 cm) from all persons and must not be near or connected to any other antenna or
transmitter.
Note: The console contains either FCC ID: OMCBBICON14 or FCC ID: OMCBMD1.
19