Table of Contents
Advertisement
Installation
passage volume of at least 31"²
2
(200 cm
) to allow the warm air to
dissipate unimpeded.
- If you wish to fit a grille in the ventila-
tion openings, the ventilation open-
ings must be larger than 31"²
2
(200 cm
). The passage volume of
2
31"² (200 cm
) is the total area of the
opening slits in the grille.
- Important! The larger the ventilation
slits, the more economically the ap-
pliance will work.
Lower ventilation slit
The appliance can be ventilated via the
cabinet plinth with the ventilation grille
supplied or with a minimum ventilation
2
opening of 31 in
When using the grille supplied, please
proceed as follows:
Cut an opening in plinth as shown
in the diagram.
Place ventilation grille in the open-
ing.
Push snap fasteners into the venti-
lation grille from behind until the
hooks touch the plinth.
Reinstall the plinth with the ventilation
grille.
20
cross-section area.
Cabinet door
An cabinet door is required.
The cabinet door must be at least 5/8"
(16 mm) / 3/4" (19 mm) thick.
– Weight of the door panel
If the door panel is too heavy
damage can occur.
Installing a door panel which is heav-
ier than the maximum permitted
weight could damage the hinges.
This can cause subsequent func-
tional problems.
Before installing the door panel, en-
sure that the weight of the door
panel does not exceed the maximum
permitted weight.
The maximum permissible weight of the
door panel is:
Refrigeration appliance
FNS 7794 E
lb (kg)
57 (26)
Advertisement
Table of Contents
