Quick Reference - Supermicro X7DA3 Plus User Manual

Quick Reference (X7DA3+)
Jumper Description
J3P 3rd PWR Failure Detect
JAR Alarm Reset
JBT1 CMOS Clear
JCF1 Compact Card Master/Slave Select
2 2
JI C1/JI C2 SMB to PCI-X Slots
2 2
JI C3/JI C4 SMB to PCI-E Slots
JPS1 SAS Controller Enable
JPL1/ JPL2 GLAN1/GLAN2 Enable
JWD Watch Dog
Connector
ATX PWR (JPW1)
Aux. PWR/CPU PWR
HD Audio (JC1)
Chassis Intrusion (JL1)
COM1 (JCOM1)
Compact PWR (JWF1)
DIMM#1A-DIMM#4B
FAN 1-8
Floppy (J22)
FP Control (JF1)
GLAN 1/2 (JLAN1)
IDE1/IDE2(Note 1 Below)IDE1 Hard Drive (JIDE1)/Compact Flash Card (JIDE2)
LE1 LED (Note 2 Below) 5V Standby PWR LED Indicator
OH LED (JOH1)
Parallel (J21)
PWR LED/SPKR (JD1)
PWR SMB (J17)
PSF
SAS#0-#3,#4-#7(JSM1/2) SAS (Serial Attached SCSI) Connectors #0-#3, #4-#7
SATA#0-#5(JS1-JS6)
SGPIO 1/2(J29,J30)
SMB (J18)
Slot 7
USB 0/1/2/3 (JUSB1)
USB 4/5 (JUSB2)
WOL (JWOL)
WOR (JWOR)
Notes: 1.JIDE2 is for Compact Card Use only. JCF1 is used to confi gure the com-
pact fl ash card as a master or a slave drive. Be sure to connect JWF1 to a power
supply to provide power to the compact fl ash card. 2. When LE1 is on, the Standby
Power is on. Unplug the PWR cables before changing components.
Description
Primary 24-Pin ATX PWR Connector
+12V 4-pin PWR (JWP2)/+12V 8-pin PWR(JPW3)
High Defi nition Audio Connector (JC1)
Chassis Intrusion Header
COM1 Serial Port Connector
Compact Card PWR Connector
Memory DDRII Fully Buffered DIMM Slots
Fans 1-8 (Fan7: CPU Fan1, Fan8: CPU Fan2)
Floppy Disk Drive Connector
Front Control Panel Connector
G-bit Ethernet Ports
Overheat LED
Parallel (Printer) Port
PWR LED(pins1-3)/SpeakerHeader (pins 4-7)
Power System Management (I
Power Supply Failure (See Chapter 2)
Serial ATA Connectors #0-5
Serial General Purpose Input/Output Headers
System Management Bus Header
SIM Low Profi le IPMI Connector
Back Panel USB 0/1/2/3(JUSB1)
Front Panel USB4/5 (JUSB2)
Wake-on-LAN Header
Wake-on-Ring Header
1-5
Chapter 1: Introduction
Default Setting
Off (Disabled)
Off (Disabled)
See Chapter 2
On (Master)
Pins 2-3 (Disabled)
Pins 2-3 (Disabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Reset)
2
C) Header