Toro 72923 Operator's Manual page 80

Figure 124
1. 7.6 cm (3 inch) at position
A is correct
2. 8.3 cm (3-1/4 inch) at
position B is correct
10. Fine-tune the adjustment nut on the front
deck-lift assembly by turning it
Figure 126).
Note:
To increase the height, turn the
adjustment nut clockwise; to decrease the
height, turn the nut counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, you
can use the single-point adjustment to gain
more adjustment.
Figure 125
5000 Series Machines
1. Adjustment nut
2. Jam nut
g009196
3. Measure here from the
blade tip to the hard
surface
4. Measure at position A and
B on both sides
(Figure 125 or
g010251
3. Rear deck adjustment
4. Front deck adjustment
6000 Series Machines
1. Adjustment nut
2. Jam nut
11. To adjust the single-point system, loosen the
2 bolts at the bottom of the height-of-cut plate
(Figure 127).
Note:
For rear-discharge machines, the mower
deck is attached in the back holes at the factory.
Refer to Figure
holes for further adjustment when leveling the
mower deck.
80
Figure 126
3. Rear deck adjustment
4. Front deck adjustment
128. If needed, use the front
g027344