Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Before You Start...
1. Read this manual carefully and completely.
2. The range hoods conform to related appliances standards. Please check your local
building codes for any additional requirements.
3. The appliance has been manufactured as class I, there-fore ground connection is
necessary. The range hood must be installed so that that the plug is easily accessible.
Planning Your Installation
Unpacking
Remove the packaging with the product in place. Cut off the packing ribbons and carefully cut
open the packaging (do not cut too deeply), remove the packaging. Check that the product is free
from transport damage. Any damage shall be reported imme-diately to the carrier or seller.
Damage, faults and missing parts must be reported immediately to the seller.
1. Measure the floor to ceiling height. This hood
can be installed on walls between 8" (203mm) and
9" (229mm) tall.
2. Find the centre point of your opening. Mark a
plumb line through this point from ceiling to your
range/cook-top.
3. Check your range/cook-top User Manual for the
minimum distance above your cooking surface.
The minimum distance between any element or
flame height and the nearest combustible surface is
650mm .
4. Decided where the ductwork will run between
the hood and the outside. Short, straight duct runs
will provide the most air flow.
5. If the unit is installed with ducting (i.e. not in
re-circulating mode) pls remove the charcoal filter.
3
Advertisement
Table of Contents
