Installation Instructions; Planning Your Installation - ILVE T11 IVCC900X-20140811 General Manual

INSTALLATION INSTRUCTIONS

Before You Start...
1. Read this manual carefully and completely.
2. The range hoods conform to related appliances standards. Please check
your local building codes for any additional requirements.
3. The appliance has been manufactured as class I, there-fore ground
connection is necessary. The range hood must be installed so that that the plug
is easily accessible.

Planning Your Installation

Unpacking
Remove the packaging with the product in place. Cut off the packing ribbons and
carefully cut open the packaging (do not cut too deeply), remove the packaging.
Check that the product is free from transport damage. Any damage shall be reported
imme-diately to the carrier or seller. Damage, faults and missing parts must be
reported immediately to the seller.
1. Measure the floor to ceiling height. This
hood can be installed on walls between 8"
and 9" tall.
2. Find the centre point of your opening.
Mark a plumb line through this point from
ceiling to your range/cook-top.
3. Check your range/cook-top User Manual
for the minimum distance above your
cooking surface.
between any element or flame height and the
nearest combustible surface is 61cm (24").
4. Decided where the ductwork will run
between the hood and the outside. Short,
straight duct runs will provide the most air
flow.
5. If a recalculating kit is necessary, you may
purchase one through your dealer.
The minimum distance