Troubleshooting - Arrma GORGON SMART 2wd 550 Mega Manual

Troubleshooting

Problem Possible Cause
Batteries are incorrectly installed in transmitter
Weak, damaged or no drive battery in model
Frayed or broken motor or ESC wires
ESC has shut down due to overheating
Vehicle does not
move Electric motor is damaged
Waterproof ESC is damaged
Possible damage to transmission/drive-line
ESC low voltage cutoff has activated to protect
batteries
Vehicle does not
Waterproof ESC is damaged
reverse
Battery damaged or not fully charged
Electric motor dirty or damaged
Short runtime
Incorrect ESC battery mode - voltage cutoff too high
for the battery you are using
Battery damaged or not fully charged
Electric motor dirty or damaged
Sluggish
performance
Drivetrain dirty or damaged
Solution
Check transmitter batteries and refit -
see model/transmitter manual
Install fresh, charged batteries
Check condition, reconnect and
insulate
Stop driving and allow ESC or motor
to cool down
Replace with new unit - visit
ARRMA-RC.com for advice and
upgrades!
Replace with new unit - visit
ARRMA-RC.com for advice and
upgrades!
Check components and replace -
visit ARRMA-RC.com for advice
Remove drive battery, leave to cool
down if necessary, and re-charge
Replace with new unit - visit
ARRMA-RC.com for advice and
upgrades
Check condition, replace or recharge
Clean, check condition and/or replace
- visit ARRMA-RC.com for more
information
Adjust the battery mode of the unit
Check condition, replace or recharge
Clean, check condition and/or replace
- visit ARRMA-RC.com for more
information
Clean, check condition and/or replace
- visit ARRMA-RC.com for more
information
24
WWW.ARRMA-RC.COM