⑩ Two Needles - JUKI HZL-UX8 Instruction Manual

⑩ Two needles
The sewing machine can be set to perform
twin-needle stitching.
Caution: When carrying out the twin needle stitching, it is necessary to set the twin needle before
selecting a pattern.
001 004 005 006
031 201 502 503
Example)
Maximum 5.0 mm
Maximum 7.0 mm
A A
3 3
D D C C
B B
F F
E E
G G
007 008 009 010
508 509 510 677
2.0 mm
2 2
4 4
H H
5 5
When you want to change the needle
or the presser foot, be sure to turn the
Attention
power OFF or place the sewing ma-
chine under the lock mode in advance.
012 014 030
835 836
Decorative sewing patterns can be sewn beautifully using
the twin needle.
When you select the twin needle setting, the stitch width
setting is limited to 5 mm at the maximum.
1
Change the needle to the twin needle.
Make sure to use a twin needle with size of 2.0 mm.
* The twin needle is separately available.
2
Place the supplementary spool pin.
3
Thread to the thread guide A first. After
that, thread paths are same up from B to
G.
* When twin needle sewing, make sure to use thread
size smaller than No. 60.
4
Do not thread H for right-hand needle.
5
Thread to right-hand and left-hand
needles separately.
* Automatic needle threader can not be used.
Thread each needle manually.
* Automatic thread trimmer can not be used in case of
twin needle sewing.
Presser foot
Standard presser foot (A)
Manual buttonhole presser
foot (I)
109