The Basics; Headset Controls; Power On Your Headset; Make, Answer, End Calls - Plantronics W8210 User Manual

The basics

Headset Controls

Power on your headset

Make, answer, end calls

1
5
6
1 Volume wheel Rotate volume wheel to adjust volume
2
Call button Press to place, answer, end a call
3
Mute button During a call, press to mute and unmute
4
Headset LED Flashes when in use
5 Power button Toggle on and off
6
ANC (Active Noise Canceling) Toggle on and off
To turn on the headset, slide the Power button on the bottom of the earcup to reveal green.
On the top of the base there are three Audio buttons: computer, mobile, desk phone. These
buttons allow you to switch to a different phone line/audio channel.
Make a call
Tap an Audio button
1
Deskphone only: Manually remove the handset if you don't have an HL10 lifter or EHS cable. You
2
should hear a dial tone.
TIP If you do not hear a dial tone, open the base side panel and adjust the middle switch (A--G). "A"
works for the majority of desk phones.
Dial from your softphone/mobile phone/desk phone.
3
Answer/end a call
To answer or end a call, tap the Audio button
TIP
Headset call control for the computer requires Plantronics software and softphone compatibility.
See "Download software."
Answer a second call
While on a call, press the headset Call button for 2 seconds to answer the second call.
1
This will place the first call on hold.
To switch between the calls, press the headset Call button for 2 seconds.
2
Reject a Mobile Call
To reject an incoming call, hold the base mobile button down for 3 seconds.
2
3
4
on the base.
on the base or tap the headset Call button.
11