Machine Description - Yamato TPR 500/13 K Instruction Manual

Cod 98872 - mod. TPR500/13 K

4. 4.MACHINE DESCRIPTION

1. Chuck
2. Ruler
3. Handle
4. Drill - impact selector
5. Rotation selector
6. Adjusting speed device
7. Lock button
8. Switch
5. OPERATING INSTRUCTIONS
Bit installation
Insert the bit into the hole. Pay attention to align the bit correctly in the chuck.
Drill or impact selection
For drilling : Push the drill - impact selector where marked with
For impacting : Push the drill - impact selector where marked with
Rotation selection
It is possible to choose the rotation way selecting moving the lever (5) in a
clockwise or counter clockwise way, as showed in picture 6.
Forward/Reverse switch
Drill driver starts and stops by depressing and releasing the switch. To reverse the
direction of rotation, stop the driver by releasing the switch and push the
reversing switch to the right or the left. When the reversing switch is set to the
right, the direction of rotation will be clockwise, when viewed from the handle
end of the drill.
When the reversing switch is set to the left, the direction of rotation will be
counterclockwise. Keep the reversing switch lever in the neutral position
whenever you are not using the tool.
Operating switch
To start operating with tool, press the switch (A), while to
stop release it.
It is possible to adjust the speed turning the speed device
(B). To increase the speed turn clockwise the device,
otherwise to reduce the speed turn counter clockwise.
When operating, it is possible to lock the switch pushing
the lock button (C).
10