Yamato TPR 500/13 K Instruction Manual page 15

Cod 98872 - mod. TPR500/13 K
✓ Pay attention to the environment, do not expose the tool in rain or humid
place. Keep work area lit up. Don't use the tool in presence of inflammable
liquid or gas.
✓ Pay attention to do not touch the grounding parts, pipes, heat elements, so
that to avoid electric shock.
✓ Take care of the tool. Put it in dry place when not in use, and far from children.
✓ Don't overload the tool. Operate only within the load level suggested.
✓ Dress properly : Don't wear loose clothing or jewelry because they can be
caught in moving parts. Rubber gloves and non-skid footwear are
recommended when working. Wear protective hair covering to contain long
hair.
✓ Use safety glasses and dust musk if operation is dirty.
✓ Never carry the tool by cord or yank it to disconnect from receptacle. Keep
cord far from heat, oil and sharp edges.
✓ Secure work. Use clamps or vise to hold work. It's safer than using your hand
and it frees both hands to operate tool.
✓ Keep proper footing and balance at all times.
✓ Keep tool sharp and clean for better and safe performance. Follow instructions
for lubricating and changing accessories. Inspect extension cords periodically
and replace if damaged. Keep handles dry, clean and free from oil and
grease.
✓ Disconnect tool when not in use, before serving and when changing
accessories, such as bits.
✓ Remove adjusting keys and wrenches. Check that keys and adjusting
wrenches are removed from tool before turning it on.
✓ Avoid unintentional starting. Don't carry plugged-in tool with finger on switch.
Be sure that the switch is off when plugging in.
✓ Outdoor use extension cord. When tool is used outdoors, use only extension
cords for that use and so marked.
✓ Watch what you are doing and use common sense. Don't operate tool when
tired.
✓ Before further use of the tool, a guard or other part that is damaged should be
carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, any other condition that may affect its
operation. A guard or other part that that is damaged should be properly
repaired or rellanced by an authorized service center unless otherwise
indicated elsewhere by dealer.
✓ Warning : Use not authorized spare parts of other machines can cause
incidents.
✓ Repair your tool only by Authorized Service Center.
9