TP-Link Archer BE9300 User Manual page 100

Chapter 15
3. Set the Tunnel IP Address
4. Select your Client Access
remote device to access your home network; select
you also want the remote device to access internet through the VPN Server.
5. (Optional) Click Advanced Settings
router will become the DNS server of the VPN client that establishes a connection
with it. Change the
heartbeat regularly, you can also click
public key.
Step 2 Create accounts that can be used by remote clients to connect to the VPN
server
1. Locate the Account List
2. Give a Username to this account.
3. View the Address
unless necessary.
4. Traffic sent from the WireGard VPN client to the allowed IPs (client) will be transmitted
through the tunnel. By default, all network traffic from clients will be transmitted
through the tunnel. Do NOT change it unless necessary.
5. Traffic sent from the WireGard VPN server to the allowed IPs (server) will be
transmitted through the tunnel. Do NOT change it unless necessary.
6. Enable or disable Pre-shared
7. Click SAVE.
Note: One account can only be used by one WireGuard VPN client at the same time to connect to the WireGuard VPN
server.
and Listen Port. Do NOT change it unless necessary.
type. Select
to display more settings. If
Persistent Keepalive
section. Click
of the virtual interface assigned to this account. Do NOT change it
Key.
Home Network Only
Internet and Home Network
time (25 seconds by default) to send out
RENEW KEY to update the private key and
Add to create an account.
VPN Server&Client
if you only want the
DNS is turned on, the
96
if