Preparation; Unpacking The Tv - JVC LT-65C880 Instruction Manual

Chapter
2

Preparation

2
Thank you
Your new TV has many features and incorporates the latest technology to enhance your viewing
experience. We recommend that you spend some time reading this instruction manual so that you fully
understand these features. You will also find some hints and tips to help you resolve any issues.
Read all the safety instructions carefully before use and keep this instruction manual for future reference.

Unpacking the TV

Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to local regulations.
The following items are included:
Left Foot
GB
Instruction Manual
65" LED Smart 4K HDR TV
LT-65C880(C)
Instruction Manual
JVC 65' LED Smart 4K HDR TV LT-65C880(C) Manual.indd 7
for purchasing your new JVC TV.
Stand screws x6
Right Foot
Setup in
Quick Start Guide
15mins
65" LED Smart 4K HDR TV
LT-65C880(C)
JVC 65' LED Smart 4K HDR TV LT-65C880(C) Quick Start.indd 1-3
Quick Start Guide
Thank you
for purchasing your new JVC TV.
Your new TV incorporates the latest technology to enhance your viewing The latest eco-friendly power-saving technology will switch off the TV if
4
experience. We would suggest that you allow about 15 mins for initial setup. it is left on and idle for 4 hours. Please refer to "Auto Standby" under the Connecting the Aerial and Turning on the TV
"Time Settings" section of the instruction manual for more detail.
Please follow this guide for a successful first time installation.
1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the ANT socket on the back of your TV.
1
What's in the Box? 2. Plug the TV into a mains socket and switch on at the mains.
3. In standby mode, press the button on the remote control to turn the TV on. The LED indicator will flash for a few seconds then the TV will switch on.
Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.
TV Remote Control/ Instruction Manual
AAA Batteries x2 Please inspect your TV for damage after unpacking. If
Right Foot Quick Start Guide
you do notice any damage please consult your dealer.
Left Foot Feet Screws x 6
2
Operating Your Remote Control
1. Slide open the battery compartment on the back of the remote control.
2. Insert two AAA size batteries. Make sure to match the (+) and ( - ) ends of the
batteries with the (+) and ( - ) ends indicated in the battery compartment.
3. Slide the battery compartment cover back into place. Make sure it clicks into place.
VGA LAN Optic.OUT ANT . HDMI 1
3
Installing the Base Stand
Fitting the Feet to the TV
1. Ensure the TV is switched off and not connected to the mains power supply.
2. Keep the protective bag on the TV to protect it.
3. Make sure you have some help, this requires 2 people. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly
overhangs the edge of the table, with the back side facing up. Please make sure a soft cushioned material (such as a dry bath towel or thick piece of foam) is
placed beneath the screen. Be very careful not to knock the edges of the TV, the screen is very fragile.
4. The feet are marked up as Left and Right. They can only be attached with the right foot on the right side of the TV as you look from the back and the left on the
left side. Attach each foot with 3 of the supplied screws. RF coaxial cable
(not included)
Protective
Bag
Router
(not included)
Optional
If you want to connect to the internet via a wired connection
then connect your ethernet cable to the LAN socket.
Cushioned
Table
material
Left Foot Right Foot
• Do not connect the TV to the mains supply until you have completed all the connections.
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object, or • Always disconnect the TV from the mains socket when not in use for a long period of time.
anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time because the • The button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.
screen could crack. To completely disconnect the mains power, please remove the mains plug from the mains socket.
LANG. LANG.
G
BACK EXIT
Remote Control /
AAA Batteries x 2
07/11/2018 10:57
7
07/11/2018 11:00