Hyundai PB55 Instruction Manual page 23

Alert Tone ON/Off
The Baby Unit will send out an alert tone when you activate the VOX function. After the alert tone,
it will transmit the detected voice signal.
· Press the MENU – button (5) 5 times.
· Press the – button (7) to enable (ON) or the – button (4)
to disable (OF) this function.
· Press the MENU – button (5) to confirm the selection.
· When this function is activated, the alert tone icon
will be displayed .
Using the Parent unit as a PMR
Beside using the Parent as receiver for the Baby unit transmission, you can use it to Communi-
cate with other PMR (Private Mobile Radio) users which are on the same channel.
Changing Channels
To use the Parent Unit as a standard PMR, the Channel Memory function must be deactivated
(See chapter 15.2) and the unit must be set to the same channel as your correspondent PMR
· Press the MENU –button (14) once, the current channel
number Flashes on the display
· Press the – button (19) or the
the channel.
· Press the PTT – button (18) to confirm and return
to stand – by mode.
Receiving a Signal
The parent Unit is continuously in RECEIVE mode when
the unit is switched ON and not transmitting .
When a signal is detected the RX icon will be displayed
Transmitting a Signal
· Press and hold the PTT - button (18) to TRANSMIT .
The TX symbol is displayed.
· Hold the unit in a vertical position with the MICROPHONE
10cm from the mouth and speak into the microphone.
· Release the ptt-button (18) when you want to stop transmitting.
To check the channel activity use the monitor function (See chapter 20.6)
VOX Selection
The PMR is capable of voice activated (VOX) transmission In VOX mode, the radio will trans-
mit a signal when it is activated by your voice or other sound around you .VOX operation is not
recommended if you plan to use your radio in a noisy or windy environment
· Press the MENU – button (14) 3 times, the current VOX
setting flashes on the display and the VOX icon is displayed.
· Press the – button (19) to turn the VOX feature ON Press
-button again to select the VOX sensitivity level which
displayed. Press the
on the display ,to turn VOX OFF
-button (20) to change
– button (18) until OF appears
EN - 23
EN