Hyundai PB55 Instruction Manual page 19

Baby unit
Using the power adapter
Plug one end of the adapter (DC 10V/300mA) into the
power outlet and the other end into the adapter jack on
the side of the baby unit . A click indicates, the jack is
locked into position.
Using batteries
Instead of using the power adapter the baby unit can
be powered by 'LR03' Alkaline (non-rechargeable)
batteries.
1. Pull the battery cover tab and gently remove
the battery cover.
2. Install 4 'AAA' 'LR03' alkaline batteries following
the polarity as shown.
3. Re-install the Battery cover.
Parent unit
Removing/Installing the Belt Clip
1. To remove the clip from the unit, push the belt
clip (B) towards the antenna,while pulling the
belt clip tab away from the unit (A).
2. When re-installing the belt clip, a click indicates
the Belt Clip is locked into position.
Battery Installation
1. Remove the belt clip (See 9.2.1.1).
2. Press the battery cover gently and slide
it away from the unit.
3. Install 3'AAA''LR03' alkaline or
Rechargeable batteries following the
polarity as shown.
4. Re-install the battery cover and belt
clip (See Chapter 9.2.1.2).
Recharging batteries
The Parent Unit can be used with 3 rechargeable
Ni MH AAA battery pack. With rechargeable
batteries installed, the batteries can be charged
with the included charger(DC 7.5V/200mA).
Only use the included AC/DC ADAPTER with "AAA" rechargeable batteries. Do not charge this
unit when regular "AAA" 'LR03 alkaline batteries are installed.
Do not connect other chargers. This may damage your device.
1. Insert four (3) "AAA" rechargeable batteries.
2. Plug the small plug of the adapter into the charger jack on the bottom of the unit and the other
end in the electrical socket.
Note: It takes approximately 12 to 14 hours to fully charge the batteries (with 600mAh).
EN - 19
EN