Advertisement
CLEANING AND MAINTENANCE
Make sure that the oven has cooled down before carrying out any maintenance or cleaning. Do not use steam cleaners. Do not
use wire wool, abrasive scourers or abrasive/corrosive cleaning agents, as these could damage the surfaces of the appliance. Wear
protective gloves. The oven must be disconnected from the mains before carrying out any kind of maintenance work.
EXTERIOR SURFACES
Clean surfaces with a damp microfibre cloth. If they are very dirty, add a
few drops of pH -neutral detergent. Finish off with a dry cloth. Do not use
corrosive or abrasive detergents. If any of these products inadvertently
comes into contact with the surfaces of the appliance, clean immediately
with a damp microfibre cloth.
INTERIOR SURFACES
After every use, leave the oven to cool and then clean it, preferably while
it is still warm, to remove any deposits or stains caused by food residues.
To dry any condensation that has formed as a result of cooking foods with
a high water content, leave the oven to cool completely and then wipe it
with a cloth or sponge.Activate the "Smart Clean" function for optimum
cleaning of internal surfaces (Available only on certain models).
Clean the glass in the door with a suitable liquid detergent.
ACCESSORIES
Soak the accessories in a washing-up liquid solution after use, handling
them with oven gloves if they are still hot. Food residues can be removed
using a washing-up brush or a sponge.
LOWER THE TOP HEATING ELEMENT (Only in some models)
The top heating element of the grill can be lowered to clean the upper
panel of the oven: Extract the heating element from its seating, then lower
it. To return the heating element to its position, lift it up, pull it slightly
towards you and make sure that the tab support is in its proper seating.
REMOVING AND REFITTING THE DOOR
To remove the door, open it fully and lower the catches until they are in the
unlock position (1). Close the door as much as you can (2). Take a firm hold
of the door with both hands - do not hold it by the handle. Simply remove
the door (3) by continuing to close it while pulling it upwards (a) at the
same time until it is released from its seating (b).
~60°
1
2
Put the door to one side, resting it on a soft surface. Refit the door by
moving it towards the oven, aligning the hooks of the hinges with their
seating and securing the upper part onto its seating.Lower the door and
then open it fully. Lower the catches into their original position: make sure
that you lower them down completely. Try closing the door and check to
make sure that it lines up with the control panel. If it does not, repeat the
steps above.
TROUBLESHOOTING
What to do if...
The oven is not working.
Download the complete Daily Reference Guide from docs.whirlpool.eu for more informations about your product
Policies, standard documentation and additional product information can be found by:
•
Visiting our website
•
Using QR Code
•
Alternatively,
contacting our After-sales Service, please state the codes provided on your product's identification
plate.
a
3
Possible reasons
Power cut.
Disconnection from the mains.
docs . whirlpool . eu
contact our After-sales Service
CLEANING OF THE DOOR GLASSES
After removing the door and resting it on a soft surface with the handle
downwards, simultaneously press the two retaining clips (1) and remove
the upper edge of the door by pulling it towards you (2).
1
Lift and firmly hold the inner glass with both hands, remove it and place it
on a soft surface before cleaning it (3).
3
To correctly reposition the inner glass, make sure that the "R" is visible in
the left-hand corner and the clear surface (not printed) is facing up. First
insert the long side of the glass indicated by "R" into the support seats,
then lower it into position (4). Refit the upper edge (5): a click will indicate
correct positioning. Make sure the seal is secure before refitting the door.
~15°
b
4
REPLACING THE LAMP
Disconnect the oven from the power supply, unscrew the cover from the
light, replace the bulb and screw the cover back on the light. Reconnect
the oven to the power supply. Do not use the oven until the light cover has
been refitted.
Please note: Only use 25W/230 ~ V, G9 type, T300°C halogen bulbs. The bulb
used in the product is specifically designed for domestic appliances and is not
suitable for general room lighting within the home. Light bulbs are available
from our After-sales Service.
Solutions
Check for the presence of mains electrical power and whether the
oven is connected to the electricity supply.
Turn off the oven and restart it to see if the fault persists.
(See phone number in the warranty booklet). When
2
5
Model: xxxXXXXxx
XXXXXXXXXXXXXX
400011632965
Advertisement
