Introduction; I.apurpose Of Test; I.blaboratory; I.cdescription Of Unit - Drolet DB03105 Installation And Operation Manual

Report prepared for: Guillaume Thibodeau-Fortin (Stove Builder International Inc.) on 12/1/2017 8:00:00 AM
Test report #103124842MTL-001 (4 of 15)
Stove Builder International Inc.
Project No. G103124842
I.

INTRODUCTION•

Intertek Testing Services NA (Intertek) has conducted testing for Stove Builder
International Inc., on model Series 2.3 – Escape 1800 Wood Burning Room Heater to
evaluate all applicable performance requirements included in "Determination of
particulate matter emissions from wood heaters."
I.A• PURPOSE•OF•TEST•
The test was conducted to determine if the unit is in compliance with U.S EPA
requirements under EPA 40 CFR Part 60 "Standards of Performance for New
Residential Wood Heaters, New Residential Hydronic Heaters and Forced-Air
Furnaces". This evaluation was conducted on 6 July 2017 to 13 July 2017. The following
test methods were applicable:
I.B• LABORATORY•
The tests on the model 2.3 Series Escape 1800 Wood Burning Heater were conducted
at the client facility in St-Augustin-de-Desmaures, Quebec located at 250 de
Copenhague, St-Augustin-de-Desmaures, Quebec, Canada G3A 2H3. The laboratory
elevation is 213 feet above sea level. The test was conducted by Claude Pelland, Eng.
and observed by Guillaume Thibodeau-Fortin of Stove Builder International Inc.
I.C• DESCRIPTION•OF•UNIT•
The model Series 2.3 – Escape 1800 Wood Fuel Room Heater is constructed of sheet
steel. The outer dimensions are 26.75-inches deep, 33.5-inches high, and 25.625-inches
wide. The unit has a door located on the front with a viewing glass.
(See product drawings.)
Stove Builder International Inc. | 35697 | Rev: Nov 30 2017 11:01AM | Uncontrolled Copy
ASTM E2515-11- Standard Test Method for Determination of Particulate Matter
Emissions Collected by a Dilution Tunnel
WK47329-14 - Standard Test Method for Determining Particulate Matter
Emissions from Wood Heaters using Cordwood Test Fuel
CSA B415.1-10 - Performance Testing of Solid-Fuel-Burning Heating Appliances
Date: 21 July 2017
Page 4 of 15
Page 205 of 245