20
4 Handling
It is obligatory that all these operations are undertaken by handling specialists.
Before any handling, check that the four transport locks fitted are still in place and well-tightened.
To do so, remove the side casings and check presence of four locks (B) and the down casings for the four locks (A).
To handle the machine, you must imperatively reassemble the transport bridles and dis engage the load cells
(proceed in reverse order or "remove of the transport locks fitted" )
4.1 Lifting with a fork-lift truck
You should never handle the machine in its longitudinal side (any other than shown on the drawing below) with a
fork-lift truck. Important risk of parts deterioration for those fixed under the machine.
This can be carried out from the front or back, and at the centre of the machine using forks with minimum length of
1.50 m (59")
4.2 Lifting with handlings straps
Lifting in that case can only be done with handling straps (minimum capacity 3000 daN / 6600 lb) which bear weight
of the machine.
Installation manual
Important
Caution
Warning