Multi Display Setting - Sony LMD-2451W Operating Instructions Manual

MARKER SETTING
USER CONFIG – MARKER SETTING
M A R K E R E N A B L E :
M A R K E R S E L E C T :
C E N T E R M A R K E R :
S A F E T Y A R E A :
M A R K E R L E V E L :
M A R K E R M AT :
Submenu Setting
MARKER ENABLE Selects ON to display the marker
and OFF not to display.
Note
When NATIVE is selected in the
SCAN setting, the marker is not
displayed.
To display the marker, select a
setting other than NATIVE.
MARKER SELECT Selects the aspect ratio according to
the film, when the frame of the film
is displayed on the screen.
When 16:9 aspect ratio is selected
with the button which the aspect
function is assigned
When 4:3 aspect ratio is selected
with the button which the aspect
function is assigned
CENTER MARKER Selects ON to display the center
mark of the picture and OFF not to
display.
SAFETY AREA Selects the safe area size for the
aspect ratio determined by the
button which the aspect function is
assigned.
You can select from among OFF,
80%, 85%, 88%, 90% and 93%.
When the marker is displayed, the
safe area for the marker is
displayed.
MARKER LEVEL Sets the luminance to display the
MARKER SELECT, CENTER
MARKER and SAFETY AREA.
You can select from among 1 to 3.
When the setting is low, the marker
is displayed dark.
MARKER MAT Selects whether you put mat on the
outside of the marker display.
• OFF: No mat is put.
• HALF: Gray mat is put.
• BLACK: Black mat is put.
xxx
xxx
xx
xxx
x
xxx
You can select from among
4:3, 15:9, 14:9, 13:9, 1.85:1,
2.35:1, 1.85:1 & 4:3 and
OFF.
You can select 16:9 or OFF.

MULTI DISPLAY SETTING

USER CONFIG – MULTI DISPLAY SETTING
M U LT I D I S P L AY E N A B L E :
M U LT I D I S P L AY:
S U B I N P U T S E L E C T :
P O S I T I O N :
F R A M E :
S U B P I C T U R E S I Z E :
Submenu Setting
MULTI DISPLAY Selects ON to display the multi display
ENABLE and OFF not to display.
Notes
• When the frame frequency of the
main display is different from that of
the sub display, the picture may be
disturbed. When no signal is input to
the main display, the picture may not
be displayed correctly.
• When the multi display is enabled,
the marker display is not available.
MULTI DISPLAY • PIP/POP: The sub display is put in
the main display for the 16:9 display
and by the side of the main display
for the 4:3 display.
• SIDE BY SIDE: The main display is
put in the left side of the display and
the sub display is put in the right side
of the display.
Notes
• When the HD15 signal is input to the
main display, SIDE BY SIDE cannot
be selected on the menu.
• When MULTI DISPLAY is set to
SIDE BY SIDE, CTI (page 22) is not
available.
xxx
xxx
xxx
x
x
x
25
Adjustment Using the Menus