Operation (continued)
4
Testing and Adjusting the Motion Sensor
□
Turn on power and allow the motion sensor to warm up for about 60 seconds. Switch the knob to Test to
go into TEST mode. Regardless of whether it is day or night, the lights will come on for approximately 2-3
seconds, every time the sensor detects motion.
NOTE: The motion sensor will need to completely warm
up (60 seconds) before beginning the setup process.
□
Perform a "walk test" to adjust the sensor coverage area. Walk in
an arc across the front of the motion sensor (A).
□
Watch the light. The light will come on indicating motion has been
detected.
□
Stop, wait for the light to turn off, and then begin walking again.
□
Continue this process until the detection zone has been established.
□
Adjust the sensor up, down, or side to side to change the motion
sensor (A) detection zone to your desired coverage area.
□
After completing the testing, switch the knob to your desired setting
and the sensor is ready to go.
5
Control The Detection Range
□
To shorten the detection distance, tilt the sensor head downward.
8
270°
A