Installation (continued)
For parallel switching connection, refer to the connection diagram for proper installation.
□
One or more motion sensor can be wired to multiple LED light fixtures, so all lights will turn on at the same
time when motion is detected by one of the sensors. Total Wattage of all lights being used added together
must not exceed 100W.
□
Red wire from motion sensors should be attached to black wire from light fixtures.
□
White wire from the house wiring, motion sensors and light fixtures should all be connected together and
secured with a wire nut.
□
Black wire from motion sensors should be connected to the black house wiring and secured with a wire
nut.
□ Turn both functional adjustment knobs of all the connected motion sensors to the same position to avoid
abnormal behaviors.
Live 120Vac (L)
Black Wire
Neu (N)
White Wire
2
Caulking Around the Light Fixture
□
Replace the gasket for your light fixture, if the existing one
is worn out or damaged.
□
Caulk around the canopy (B) and the mounting surface with
silicone sealant (not included).
(Load)
Red Wire
6
B