Mitsubishi Electric TRANE CITY MULTI TPCFYP015KM140B Technical & Service Manual page 39

OPERATING PROCEDURE
10. Removing the pipe thermistors/Liquid (TH22) and Gas
(TH23)
(1) Remove the air intake grille. (See Figure 1, 2)
(2) Remove the left and right side panels. (See Figure 3)
(3) Remove the under panel. (See Photo 13)
(4) Remove the drain pan. (See Photo 14, 15, 16)
(5) Disconnect the connector CN44 (white) from the indoor
controller board.
(6) Remove 6 screws from the pipe cover and remove the
pipe cover. (See Photo 14, 17)
(7) Remove the fastener for wires and remove the thermistors
(liquid and gas) from each holder. (See Photo 18)
11. Removing the guide vane
(1) Remove the intake grille. (See Figure 1, 2)
(2) Remove the side panel (right and left). (See Figure 3)
(3) Remove the under panel. (See Photo 13)
(4) Remove the drain pan. (See Photo 14, 15, 16)
(5) Remove the screw from the guide vane, then remove
the guide vane.
12. Removing the Auto vane
(1) Remove the intake grille. (See Figure 1, 2)
(2) Remove the right side panel. (See Figure 3)
(3) Remove the vane motor and cover. (See Photo 12)
(4) Slide the auto vane to the vane motor side.
(5) Remove 2 axes from each vane support pushing the
vane support to the vane sleeve side.
TCHT002
PHOTOS & ILLUSTRATIONS
Photo 17
Pipe cover fixing
screws
Pipe cover
Photo 18
Liquid pipe
thermistor
Photo 19
Screw
Photo 20
Vane sleeve
39
Pipe cover fixing
screws
(See Photo 15)
Gas pipe
thermistor
Fastener
Drain pan
Guide vane
Vane support Vane
Vane motor side