Mitsubishi Electric TRANE CITY MULTI TPCFYP015KM140B Technical & Service Manual page 32

Switch Pole
• To operate each indoor unit by each remote controller when installed 2 indoor
units or more are near, Pair No. setting is necessary.
Pair No. setting is available with the 4 patterns (Setting patters A to D).
Make setting for J41, J42 of indoor controller board and the Pair No. of
wireless remote controller.
• You may not set it when operating it by 1 remote controller.
Setting for indoor unit
Jumper wire J41, J42 on the indoor controller board are cut according to
the table below.
Wireless remote controller pair number:
Setting operation
1. Press the SET button (using a pointed implement). Check that the
remote controller's display has stopped before continuing.
J41, J42
MODEL SELECT flashes, and the model No. (3 digits) appears (steadily-lit).
Wireless
2. Press the MINUTE button twice. The pair number appears flashing.
remote
3. Press the temperature
controller
4. Press the SET button (using a pointed implement). The set pair number is
Pair No.
displayed (steadily-lit) for 3 seconds, then disappears.
Setting pattern
A
B
C
D
Pair No.4-9 of wireless remote controller is setting pattern D.
Drain pump and fan are activated simultaneously after the connector
SWE is set to ON and turn on the power.
SWE
SWE
Test run
for
OFF
Drain
The connector SWE is set to OFF after test run.
pump
(Option)
TCHT002
Operation by switch
buttons to select the pair number to set.
Indoor controller
Pair No. of wireless
Jumper wire
remote controller
J41 J42
— —
Cut —
— Cut
Cut Cut
SWE
ON OFF ON
0
Factory setting
1 —
2 —
3 —
32
Effective
Remarks
timing
<Initial setting>
Pattern A
MODEL SELECT
ON/OFF TEMP
FAN AUTO STOP
Under AUTO START
MODE VANE
CHECK LOUVER
operation
TEST RUN
or
SET RESET CLOCK
suspension
SET button
<Initial setting>
SWE
Under
operation
OFF ON
Pair No.
Model No.
Temperature
button
h
Minute
button
min