SECTION 5: MAJOR COMPONENTS
FIGURE 13: Major Component Descriptions - Standard Reflector
Burner Tube
Supplied in 10' (3 m) lengths.
Burner tube is always the first
tube after the burner.
Tube and Reflector Hanger
with Clamp Package
Position this hanger no more
than 4" (10 cm) away from the
burner.
Tube and Reflector Hanger
Suspend system from these
hangers.
Reflector Support Strap &
Wire Form
Flex Gas Line with
Shut Off Cock
Burner with Tube
Gasket
Must be installed with
the flame observation
window facing down.
Standard
Reflector
(Aluminum or
Stainless
Steel)
Alternate overlap as
shown on overview and on
Page 19, Figure 17. Minimum
overlap is 6" (16 cm).
Tube
Hot rolled or heat
treated aluminized tube
supplied in 10' (3 m) lengths.
Vent Adapter
Install turbulator
as specified in the
"Turbulator Installation" chart.
See Page 22, Step 6.4.
Turbulator is not required on the
AG-175.
SECTION 5: M
C
AJOR
OMPONENTS
Coupling Assembly
with Lock
Reflector End Cap
Punch out center
section to
accommodate tube.
Turbulator
11 of 57