Table of Contents
Advertisement
4.3 Rotary selector
Use the rotary selector to change the setting values
that are shown in the display.
If you have reached the minimum or maximum value
for setting values, e.g. the temperature, this value re-
mains in the display. If required, use the rotary selector
to turn the value back again.
For lists, e.g. the types of heating, the first value starts
again after the last value.
4.4 Display
The display shows the current setting values.
The value that you can change in the display is high-
lighted in colour.
Status bar
The status bar is at the top of the display.
The time and set time functions are shown in the status
bar.
Progress line
The line is shown in the display below the highlighted
value.
The progress line shows you how much the appliance
has already heated up or how much time has elapsed.
The line is filled from left to right.
Countdown
You can view the countdown time or the cooking time
for the previous operation in the top right in the status
bar.
If you have set a cooking time and the cooking time is
deleted, the countdown time takes over from the time
that has already elapsed from the cooking time. You
can therefore always check how long the operation has
already been running.
Temperature display
The heating-up control and the residual heat indicator
show you the temperature in the cooking compartment.
Due to thermal inertia, the temperature that is displayed
may differ slightly from the actual temperature inside
the cooking compartment. You can use the
to check the current temperature.
¡ Heating-up control
After the operation starts, the heating-up indicator
displays the rising temperature in the cooking com-
partment. When you are preheating the appliance,
the optimal time to place your food in the cooking
compartment is as soon as all the bars are filled.
For set levels, e.g. for grill settings, the heating-up
indicator is not displayed.
¡ Residual heat indicator
When the appliance is switched off, the display
shows the residual heat in the cooking compart-
ment. The residual heat indicator goes out at ap-
prox. 60 °C.
4.5 Cooking compartment
The functions in the cooking compartment make your
appliance easier to use.
Shelf supports
The rails in the cooking compartment enable you to
place accessories at different heights.
→ "Accessories", Page 10
Your appliance has three shelf positions. The shelf pos-
itions are numbered from bottom to top.
The rails are equipped with pull-out rails on one or
more levels, depending on the appliance type.
You can remove the rails, e.g. for cleaning.
→ "Rails", Page 35
Self-cleaning surfaces
The self-cleaning surfaces in the cooking compartment
are coated with a porous, matt ceramic layer and have
a rough surface. When the appliance is in operation,
the self-cleaning surfaces absorb splashes from roast-
ing or grilling and break them down.
The following surfaces are self-cleaning:
¡ Back wall
¡ Ceiling
¡ Side walls
Use the cleaning function regularly to help retain the
cleaning ability of the self-cleaning surfaces and pre-
vent damage.
button
→ "Cleaning function ", Page 28
Lighting
One or more oven lights illuminate the cooking com-
partment.
When you open the appliance door, the light in the
cooking compartment switches on. If the appliance
door remains open for longer than 15 minutes, the light
switches off again.
For most operating modes, the lighting is switched on
during operation. The lighting switches off again when
the operation ends.
Cooling fan
The cooling fan switches on and off depending on the
appliance's temperature. The hot air escapes above
the door.
ATTENTION!
Do not cover the ventilation slot above the appliance
door. The appliance overheats.
▶
Ensure that the ventilation slots are unobstructed.
Familiarising yourself with your appliance en
7
Advertisement
Table of Contents
