H) Trimming The Model Helicopter - Reely HCP80 3D Operating Instructions Manual

h) Trimming the Model Helicopter

First start the transmitter, then the model.
Push the pitch stick (also see figure 1, item 17) from the bottom position (engine off) carefully forward and observe the
response of your model. Shortly before the helicopter starts hovering, you can already determine in which direction
your model wants to move.
Tail trimming:
If the helicopter is to turn to the right with the tip of the fuselage, reduce the speed until the helicopter is standing safely
on its skids again, and then push the trim button for the tail function (also see figure 1, item 15) repeatedly to the left.
Push the pitch stick carefully forward and check if the adjustment was sufficient. Keep repeating this procedure until
the helicopter no longer has any tendency to turn to the right.
If the tip of the fuselage turns to the left, press the trim button for the tail function to the right.
Every operation of a button is confirmed by a short signal sound. The display shows the change of the tail
trimming at the trimming display (see figure 5, item 8).
If the button is pushed and held, the remote control will emit a quick sequence of signals and the trim dis-
play will move sideways more quickly. The trim middle setting is indicated by a higher signal sound. The set
value for tail trimming is automatically saved and must be re-adjusted after each activation of the remote
control.
Figure 17
85