Setting Up The Transmitter; A) Inserting The Batteries; B) Switching On The Transmitter - Reely HCP80 3D Operating Instructions Manual

9. Setting up the Transmitter

In the further course of these instructions, figures in the text always refer to the adjacent figure or the figures
within the section. References to other figures are indicated with the corresponding figure number.

a) Inserting the Batteries

The power supply of the transmitter requires 4 AA/mignon batteries (e.g. Conrad Item no.: 652506, order 4x).
Important:
Use batteries only (1.5 V/cell) instead of rechargeable batteries (1.2 V/cell) for transmitter power supply.
Proceed as follows to insert the batteries:
Lift the battery compartment lid (see figure 2, item 24) at the
lower edge and fold it up.
Insert four type AA/mignon batteries with correct polarity (ob-
serve plus/+ and minus/-) according to the specifications at
the bottom of the battery compartment (1). The spiral-shaped
spring contact (2) always must be connected to the minus pole
of the battery (3).
Fold down the battery compartment lid and let it latch.

b) Switching on the Transmitter

Move the control stick for the pitch and tail functions (also see
figure 1, item 17) to the bottom position right at your body.
Check the position of the toggle switches. All switches should
be in the forward or bottom positions (see arrows in the figure
on the right).
Slide the on/off switch (also see figure 1, item 7) from the lower
switch position (off) up to the position (on).
Figure 3
Figure 4a
73