Setting Up The Transmitter; A) Inserting The Batteries - Reely 20 92 64 Operating Instructions Manual



9. Setting Up the Transmitter

In the operating instructions, the numbers in the text always refer to the figure opposite or the figures within
the section. Cross-references to other figures will be indicated by the corresponding figure number.

a) Inserting the Batteries

The power supply of the transmitter requires 6 mignon batteries (e.g. Conrad Item No.: 652506, please order 6x).
Important:
Use batteries only (1.5 V/cell) instead of rechargeable batteries (1.2 V/cell) for transmitter power supply.
Proceed as follows to insert the batteries:
The 3 compartments for the transmitter batteries are
on the back of the transmitter casing.
Press up the latch of the medium battery compartment
lid (1) and remove the lid. Insert four mignon batteries
into the battery compartment according to the indica-
tions at the bottom (2).
Then reattach the battery compartment lid and let the
latch (3) catch.
Slide the covers of the right and left battery compart-
ments (4) off downwards. Insert one mignon battery
each into the battery compartment according to the in-
dications at the bottom.
Slide on both battery compartment lids again from be-
low until the latches (5) catch again.
36
Figure 2