Special Safety Instructions For This Unit - Hyundai VK 113 Instruction Manual

• Do not try to repair the appliance on your own. Always contact an authorized technician.
To avoid the exposure to danger, always have a faulty cable be replaced only by the
manufacturer, by our customer service or by a qualified person and with a cable of the same
type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety Instructions for this unit".

SPECIAL SAFETY INSTRUCTIONS FOR THIS UNIT

• Before using for the first time, check whether the voltage rating on the product corresponds to the
voltage of your home electric current.
• The kettle should not be placed on an untreated wood surface. Place the product on heat
resistant flat and dry surfaces only.
• Do not place the unit underneath any wall-cupboards or hanging objects, nor directly by a wall or
in a corner.
• Close supervision is necessary for any appliance being used by or near children or disabled
people.
• Let the kettle cool down completely before cleaning or storing.
• Do not allow the cord or the product itself to touch hot surface and make sure it is placed in such
a way that the unit cannot accidentally be upset by anyone pukliny the power cord.
• Do not operate the kettle if it has been dropped or damaged. Take it to an authorized service
center for examination and repair.
• Never disassemble the product; incorrect reassembly can increase the risk of electric shock when
the kettle is used. All repair work should be carried out only by an authorized service center.
• Do not use the kettle without filter.
• Do not use the appliance outdoors.
• The appliances are not intended to be operated by means of an external timer or separate
remote-control system.
IMPORTANT !
• As there is the risk of burns, always close the lid and lock it properly when you are going to turn
the kettle on. Never open the lid while hot water is inside and /or the steam density is too high.
• The lid or outer surface may get hot when the appliance is operating. The temperature of
accessible surface may be high when the appliance is operating.
• Before switching on the kettle ensure that the water level is between MIN and MAX marks only.
• There is a cut-off device that works if the kettle is overheated. It switches the kettle off when
there is no water inside or the water level is too low. Wait until the kettle cools down completely
to start boiling after the cut-off device was activated. The kettle will not turn on while too hot.
Before switching on the kettle always check that there is water inside the kettle and the water
level is not too low.
• Fill the kettle with cold water only.
• Switch the kettle off before removing it from the base.
• The kettle must be used only with the base provided.
• If the kettle is overfilled, boiling water may be ejected. Don´t overload above the MAX mark on
the kettle!
ENG - 19
ENG